
139
Chapter 7: 10-Gb Ethernet Switch Firmware
OSPFv3
The OSPFv3 link allows you to configure the OSPFv3 protocol through the following
tabs:
• Basic Settings
• Interface
•Area
By default, the B
ASIC SETTINGS tab is loaded.
Table 7-86. OSPF AS External Aggregation Configuration
Parameter Description
Network Specifies the IP address of the Net.
Mask Specifies the Subnet mask.
Area ID Specifies the ID of the area.
Aggregation Effect Indicates whether or not Type-5/Type-7 will be aggregated.
Translation
Specifies whether the P-Bit setting in the generated Type-7 LSA is
Enabled/Disabled.
Comentarios a estos manuales