Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Manual de usuario Pagina 192
- Pagina / 334
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Superblade Network Modules User’s Manual
106
LoopBack Settings
Clicking on the LOOPBACK SETTINGS tab brings up the LOOPBACK BASIC SETTINGS page
(Figure 7-84). Table 7-62 lists the parameters found on this page.
Figure 7-84. LoopBack Basic Settings Page
Table 7-62. LoopBack Basic Settings Page Parameters
Parameter Description
LoopBack Interface Specifies the Loopback Interface that is to be created.
Interface Type Specifies the interface type as Loopback (this field is not configurable).
Interface Status Specifies the Interface Status.
IP Address Specifies the IP Address for the Loopback interface.
Subnet Mask Specifies the Subnet mask for the given IP Address.
Broadcast Address
Specifies the Broadcast address for the specified IP address. This is a
read-only field.
- SuperBlade 1
- Network Modules 1
- User’s Manual 1
- REPRODUCTIVE HARM 2
- About this Manual 3
- Manual Organization 3
- Table of Contents 5
- List of Figures 15
- List of Tables 21
- Chapter 1 25
- Introduction 25
- 1-4 Contacting Supermicro 26
- Chapter 2 27
- System Safety 27
- 2-4 Operating Precautions 28
- Chapter 3 29
- Setup and Installation 29
- SBM-GEM-001 30
- Switch Modules 30
- Removing a Switch Module 31
- Network Connection 33
- SERNAME box 34
- Address Defaults 35
- Command Line 36
- Firmware Upgrading Procedures 37
- Chapter 4 43
- InfiniBand Module 43
- InfiniBand Switch LEDs 45
- Chapter 5 47
- Ethernet Switches Modules 47
- LED Indicators 48
- 1 Module Release Handle 51
- 2 RJ-45 Ethernet Ports 51
- 3 Ethernet Port Status LEDs 51
- Chapter 6 55
- 1-Gb Ethernet Switch Firmware 55
- WITCH STATUS screen in the 56
- 6-1 Port Status 57
- Port VLAN ID (PVID) 58
- Jumbo Frames Support 58
- Control Description 59
- 6-2 Statistics 60
- 6-3 VLAN 63
- 6-4 Configuring a Static VLAN 65
- 6-5 Trunking 66
- 6-6 Mirroring 68
- 6-7 Quality of Service 69
- 6-8 Rate Control 71
- 6-9 L2 Management 72
- ELETE link for that 73
- DDRESSES 73
- 6-10 Spanning Tree 74
- Port Transition State 75
- NABLE RSTP dialog 76
- PPLY GLOBAL SETTINGS button 76
- Root Status 77
- Bridge Setting 77
- RSTP Port Settings 78
- 6-11 IEEE 802.1x 79
- 802.1x Configuration 80
- 6-12 IGMP Snooping 81
- 6-13 SNMP 83
- Chapter 7 87
- 7-2 Login 88
- 7-3 Home Page 89
- Page Header Links 90
- Navigation Bar 90
- Control Pane 90
- System Acknowledgement Page 91
- 7-4 System Management Page 92
- System Information 93
- Save and Restore 95
- System Settings 98
- GENT CONTROL SETTINGS page 99
- Community 101
- Storage Type 102
- Group Access 103
- Parameter Description 104
- Target Address 106
- Target Parameter 107
- Trap Manager 110
- Basic Settings 111
- Ethernet Statistics 113
- TACACS+ Server 116
- Server Config 117
- Global Settings 118
- OGGING tab is loaded 119
- IP Authorized Manager 121
- ONFIGURATION page 122
- IP Standard ACL 124
- IP Extended ACL 125
- ASIC SETTINGS tab is loaded 126
- Classmap 128
- Policymap 129
- COSQ Algorithm 130
- Cosq Traffic Class 131
- 7-5 Layer2 Management Page 132
- Port Manager 133
- Port Monitoring 135
- Traffic Class 136
- Port Control 137
- Rate Limiting 138
- Port Settings 141
- Static VLANs 142
- Protocol Group 143
- Port Protocol 144
- Port MAC Map 145
- UnicastMAC 146
- Wildcard 147
- Switch Port Filtering 148
- Dynamic VLAN 149
- Garp Timers 151
- Port Status 156
- Port Configuration 160
- VLAN Mapping 162
- CIST Port Status 164
- Interface Settings 167
- Port Channel Settings 168
- Port State Info 172
- Load Balancing 173
- Local AS 179
- Radius Settings 180
- MAC Session Info 181
- NICAST FILTER tab is loaded 182
- Unicast Filters 183
- Multicast Filters 184
- Multicast Forwarding 186
- 7-6 Layer3 Management Page 187
- NTERFACE tab is loaded 188
- VLAN Interface 189
- IPv4 AddrConf 190
- IP Route 191
- LoopBack Settings 192
- IPv6 Route 193
- IPv6 Interface 194
- ND Cache 196
- Address Settings 198
- Address Profile 199
- Prefix Settings 200
- DHCP Server 201
- Pool Settings 202
- DHCP Relay 203
- Interface Conf 205
- Interface 207
- Neighbors 209
- Security 210
- Summarization 211
- RIP6 Interface 212
- Virtual Interface 220
- Neighbor 221
- RRD Route 222
- Aggregation 223
- AsExtAggregation 224
- Multi-Exit Discriminators 234
- Local Preference 235
- Route Aggregation 238
- OSPF Routes to BGP 241
- BGP Routes to OSPF 243
- VRRP Settings 248
- Layer 3 Tunnel 249
- 7-7 Multicast Page 250
- IGMP Snooping Configuration 251
- Interface Configuration 254
- Router Ports 256
- Group Information 257
- Dynamic Multicast 258
- Source Information 264
- Component 267
- Interfaces 268
- Candidate RP 269
- Threshold 270
- Static RP 271
- Component ID 272
- Address Type 272
- Static Group Address 272
- Static Group Mask 272
- Static RP Address 272
- 7-8 Stack Configuration Page 275
- Stack Settings 276
- Stack Details 277
- Stack Brief 278
- Stack Counters 279
- 7-9 Statistics Page 280
- Ethernet 283
- IPV6 Interface 284
- Current dB 286
- Port Statistics 287
- Multicast Table 288
- Counter Statistics 289
- Capabilities 290
- FDB Entries 291
- Information 292
- CIST Port Statistics 295
- MSTI Port Statistics 296
- PortLACP Stats 297
- Neighbor Stats 298
- Session Stats 299
- Supp-Session Stats 300
- Mac-Session Stats 301
- IGMP Snooping 302
- IGS Clear Stats 303
- IGS Statistics 304
- IGS V3 Statistics 305
- ARP Cache 306
- ICMP Statistics 307
- Interface Statistics 309
- Route Information 310
- Link State Database 312
- RP Information 315
- OUTES tab is the default 316
- Multicast Routes 317
- Prune Forward 318
- (Figure 7-192) 319
- Appendix A 323
- HCA Mezzanine Cards 323
- A-2 Mezzanine HCA Cards 324
- A-3 Installation 326
- Card Installation 327
- Appendix B 329
- LED Descriptions 329
- Appendix B: LED Descriptions 331
- Disclaimer 333
© 2020, manymanuals.es. Todos los derechos reservados | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales