
181
Chapter 7: 10-Gb Ethernet Switch Firmware
Component
Clicking on the COMPONENT tab opens the PIM COMPONENT CONFIGURATION page
(Figure 7-142). Table 7-116 lists the parameters found on this page.
Figure 7-142. PIM Component Configuration Page
Table 7-116. PIM Component Configuration Page Parameters
Parameter Description
Component ID Specifies a number uniquely identifying the component.
Candidate CRP Hold Time
Specifies the hold time of the component when it is a candidate RP in the
local domain.
Mode Specifies the mode of the component. It can be either Sparse or Dense.
BSR (Bootstrap Router)
Address
Specifies the IP address of the bootstrap router for the local PIM region.
This is a read-only field.
BSR Expiry Time
Indicates the minimum time remaining before the bootstrap router in the
local domain is declared down. This is a read-only field.
Comentarios a estos manuales