
163
Chapter 7: 10-Gb Ethernet Switch Firmware
Layer 3 Tunnel
Clicking on the LAYER 3 TUNNEL link opens the TUNNEL INTERFACE CONFIGURATION page
(Figure 7-128). Table 7-104 lists the parameters found on this page.
Pre-emption Allows you to set the Preempt mode as Enabled/Disabled.
State Indicates the current state of the Virtual Router.
Status Specifies the Admin Status of the Virtual Router.
Figure 7-128. Tunnel Interface Configuration Page
Table 7-104. Tunnel Interface Configuration Page Parameters
Parameter Description
Tunnel Alias Specifies the Tunnel Interface Alias.
Source Indicates the address of the local end point of the tunnel.
Table 7-103. VRRP Settings Page Parameters (Continued)
Parameter Description
Comentarios a estos manuales